Plastic equipment has a wide range of uses in environments that are highly corrosive, exceedingly humid, come in contact with food or many medical applications.   Plastics in these applications can be more cost effective by avoiding expensive coatings and alloys, minimizing painting, maintenance and clean up, as well as extending life of the products.  There are many different kinds of plastics available for use in these fields. Here at H3 we can tailor make any of them to suit your applications needs. 

Flexible lining can offer many types of solutions, with the ability to line almost anything.  Liners can be measured and from fitted to any shape offering very little dimensional changes to your structure.  Additionally liners can be a faster solution than coatings which demand long cure time and extensive prep and installation times.  Typical installation time for a lining can be as short as a day or as long as a week depending on the size of your project but, once a liner is in place it can be put in service immediately.  On most projects a liner can be produced in approximately two to three weeks from the date of order and installed thereafter, or in phase with the delivery of the linings, depending upon the customer’s schedule.

• Short install times

• Fast delivery and turn around

• No prep or cure time

• Limitless shapes and possibilities

Most linings, dependent upon their age and condition, can be repaired should some form of damage happen. We also offer the ability to perform inspections on a rotating basis or a per job basis to help prevent catastrophes and prolong our products.  All maintenance and inspections include a service report and status report on the current conditions of your liner.

If you need a rigid tank built to with stand a chemical you have or need a flexible liner for secondary containment of whole area we can offer you both.  Rigid products offer you a sturdy solution that will hold or support what you need, where a flexible product may be what you need to get more life out of an existing tank or process.